The Canadian Guitar Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
888 Posts
Discussion Starter · #1 ·
Ok here it is. I'm redoing a old guitar I have and I'm changing the p/u's. My first question is about the old wiring. The humbucker(bridge) is wired with a coil-tap but it only has three wires coming from it. One is ground of course and the other two go to the mini switch. From the switch one wire is grounded(soldered off of the side of the switch) and one runs to the p/u selector switch. Is this wierd? I thought it should have four wires???

On to my next question. I'm putting in a GFS lil Killer(neck) and it is a four wire. I understand(I think :D ) how to wire it. But my question is, because the neck and bridge are never on together(three p/u's) can I use the same mini switch as the bridge p/u for the neck p/u???
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top