The Canadian Guitar Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
92 Posts
Discussion Starter · #1 ·
I took my PM-20 in to get the wiring changed to two volumes and no tones or push pulls for splitting (I wanted it wired like a Les Paul without the tones). It came back to me with a bad ground or something that caused extreme noise. I took it back and they tried again......when I got it home it did the same thing. I decided that I would attempt to wire it myself and I came up with the same noise issue. The question is, does anyone have the original pm-20 wiring schematics? I have searched the web and come up empty. :confused-smiley-010
 

· Registered
Joined
·
92 Posts
Discussion Starter · #3 ·
SCREEM said:
try the parker forum, but the wiring is basic for non push/pull pots, I would remove the push/pull pots for traditional ones, and use seymore duncans schematics on their site....good luck
That’s exactly what I have done.....but still it sounds like a ground is off. Any other ideas?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top