The Canadian Guitar Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,065 Posts
Discussion Starter · #1 ·
Well, I did it! I finally started cutting holes in my blank. Neck pocket and pickup cavities are done, but I have to line up a time to use my buddy's bandsaw to cut out the body, and being the impatient boy that I am, now that I've started I think I will move onto the control and switch cavities before I get into his shop. Is it better to drill the shaft holes for the switch and pots BEFORE or AFTER routing out the cavities?
And now onto my original question: I will be shielding the control cavity, but is it overkill to try to do the pickup and switch cavities as well? The way I plan to wire it is with a pot for each pup doing the single coil to double coil blend. I was wondering if the single coil part of that equation would make it necessary to shield the pup holes...
-Mikey
 
1 - 2 of 2 Posts
Top