[GuitarsCanada]

With regard to my Rockman XP100 that I am revamping. This amp came with two Pyle Driver 6.5" speakers. The one speaker was connected to the circuit board via a harness that plugged into a three pronged connector. I have searched high and low to see if there is something like that out there, to no avail. Has anyone ever seen anything like this? Know where I might find such a thing? The speakers themselves are nothing out of the ordinary. I wish I had the speakers and I could get the harness off them. But they are gone.

 

[GuitarsCanada]

Thanks Bill... uumm since I am no expert. The speaker has two coneections, this harness has three. So when you go to wire it... whats the procedure? I will check out this place you are talking about. Perhaps they have instructions. Thanks again.

I suppose I could just solder the speaker wires to the back of the board.. the connector is just there as a quick connect.

 

[GuitarsCanada]

Thanks Bill... I may have to drop in. The back of the board has the three pins of course but the one pin goes nowhere, it has no foil going anywhere. You are correct about the speakers. There are two and only the one goes into this board. The other speaker runs off a normal plug out the back of the amp. I opened up my XP212 to look at that board and the speakers are soldered directly to the bottom of the board. This has the same circuit board as the XP100 except that the XP212 is a combo amp and the XP100 is like a big boom box.

 

[GuitarsCanada]

This is excellent news Bill. I have a few old machines around here I can dig into. I will get what I need from there. Of course I will let you know if I blow the whole thing up. I have new speakers and the caps I need on order so will maybe be ready to fire it up in a week or so. Thanks for all the help.