The Canadian Guitar Forum banner

need a replacement fan for a Marshall AVT100 Amp

3024 Views 3 Replies 3 Participants Last post by  jlemoine
Hi All

Does anyone know where to get replacement parts for Marshall Amps?

My son has a ValveState AVT100 AMP, the little fan in back is making a lot of
noise and needs to be replaced. It is the same size as those found in
many computers (40mm) but is 24 volts, most computer fans are 12v.
Marshall does not seem to publish a spares list and I don't know of any
good repairshops that would have this part in the Edmonton area.

Thanks
John
1 - 4 of 4 Posts
Did you could check with the repair depts at Long and McQuade, Axe, etc. ?
L&M repairs = over priced. go to a local shop
Thanks, I fixed it myself

Thanks for the suggestions, I ended up buying a 12 Volt fan at my local
computer shop and put a resistor in line with it to bring the voltage down
to a workable level.
A 330 Ohm 1 watt resistor in series seems to bring the volatge down to around 12 volts.

John Lemoine :smile:
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top