The Canadian Guitar Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
921 Posts
Discussion Starter #1 (Edited)
Hi folks. Here are some pics of my latest project, a pedal board constructed from a single piece of cedar originally cut from a four inch slab. Using a router and a jig, the underside was cut on an angle and the inside hogged out for weight relief and to make room for power supply, AC wiring and cable management. After some sanding, several thin spray coats of Satin polyurethane, a couple of Pewter handles from Lee Valley and rubber feet underneath for support, it was ready for some new pedals.





 

·
Registered
Joined
·
3,533 Posts
Truthfully, I opened this thread thinking it was going to be really tacky...
But damn does that look good. I’d call it a cedar wedge pedal board.

Want
 
1 - 11 of 11 Posts
Top