The Canadian Guitar Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4,716 Posts
Discussion Starter #1
I pulled this transformer out of an old ART amp from the 90's a while ago. Just curious if any of you think it might be a good useable Transformer for a project. I know nothing about transformers.



PS-PD TRANSFORMERS Chassis Mount
General Specifications
  • Power from 1.4VA to 100VA
  • Primary to Secondary Isolation – 2,500Vrms
  • Primaries – Single or Dual (115V or 115/230V – 50/60Hz)
  • Secondary – Single center tapped secondary
  • Terminals – Solder lug / quick connect type
  • Insulation System – Class B, 130 deg C
  • UL 1446 recognized


Dual Primary 115/230V
PD-7836
Size - 8
36VCT @ 2.8A
 

·
Registered
Joined
·
5,416 Posts
It was a solid state amp, I guess? That's about all you would use it for, probably in the 50 to 60W output range.
Or if you wanted to build some kind of split (+/-) power supply it could also be used.
 

·
Registered
Joined
·
4,716 Posts
Discussion Starter #3
It was a solid state amp, I guess? That's about all you would use it for, probably in the 50 to 60W output range.
Or if you wanted to build some kind of split (+/-) power supply it could also be used.
Yea, it was SS with one of those mini tubes in it. Doubt if I'll use it for that type of amp. Thanks for the info. I'll hold onto it in case someone needs something like that at some point.
 
1 - 3 of 3 Posts
Top