The Canadian Guitar Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
644 Posts
Paul, Just a little warning if you haven't already installed the bridge. A tune O matic bridge requires a neck angle of between 2.5 & 3 degrees for it to work properly. If your guitar has a bolt on neck it should be fairly easy to accomodate with a shim but if it's a set neck I wouldn't drill any holes for the bridge and tail stop before you ensure that you have enough neck angle so that your strings are not a half inch off the neck at it's lowest setting. If it had a tune o matic bridge to begin with then you will be fine. Good luck

ps. If you find that your tune o matic won't work for you, pm or email me and I will give you what you paid for it as I can always use it in the future.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top