The Canadian Guitar Forum banner

cabling question

684 Views 7 Replies 5 Participants Last post by  ezcomes
i don't think this is an issue but here is my question...

if i built an ABY switch to go between two sets of pedals...when i get to the end of each line, and want each line to continue down the same singular path, can i sum them easily with a Y cable into the next pedal?

i don't think it's an issue of grounding, and i don't think that it would load the line either...but...that is why i ask...
1 - 1 of 8 Posts
I would think that ideally you want to have some sort of mixing. That could be as simple as a 10k resistor in series with each input at the receiving Y junction.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.